Specifications

❏ 1. Remove the buggy, transmitter and parts from

the box.

❏ 2. Remove the twist-tie from the receiver antenna

wire. The receiver wire looks like a bundled thin wire

that is attached to the receiver. Run the length of the

antenna wire through your fingers to help straighten

the wire out, this will make it easier to get the wire

through the tube. Remove the antenna tube from the

decal bag. Slide the antenna wire through the antenna

tube. Do not coil or cut the antenna. Cut two pieces

of fuel tubing 1/8" wide and slide them over the outside

of the antenna tube and wire. This is to help hold the

antenna tube on and avoid getting the antenna wire

cut in a roll over. Note the placement of the tubing on

the antenna tube.

❏ 3. Remove the air filter parts from the parts pack.

Slide the large rubber O-ring around the threads of the

outer housing. The O-ring will help seal the air filter

together. Soak the air cleaner element with an air filter

oil, light machine oil, or, in a pinch, shock oil.

Thoroughly soak the foam element and squeeze out

the excess. Then install the filter element into the

plastic outer housing.

❏ 4. Press the “L” shaped boot onto the bottom housing

of the air filter. Using one of the included tie-straps,

secure the boot onto the bottom housing. Cut off the

excess portion of the tie-strap. Screw the bottom and

outer filter housing together. Note: Overtightening will

strip the threads.

❏ 5. Place the air filter onto the carburetor. Using the

remaining included tie-strap, secure the air filter to the

carburetor. Cut the excess portion of the tie-strap off to

avoid interference.

❏ 6. Locate the pre-drilled wing and place it onto the

wing mount plate. Make sure that holes in the wing line

up with the wing mount plate. Place a tapered black

plastic washer over each of the two holes. Then insert

a 3x12mm screw through the washer and wing into the

wing support. (Make sure not to overtighten the

screws holding the wing on to avoid stripping the

holes in the wing support).

WING MOUNTING

AIR FILTER INSTALLATION

ANTENNA INSTALLATION

FINISHING THE AXIS RTR VERSION (DTXD70**)