Specifications

❏ 48. Remove the throttle and steering servo horns

from the servos. Turn on the transmitter, then turn on

the receiver. Center the trims on the transmitter (see

your radio instructions). Place the horns back onto the

servos as shown. Make sure the wheels are pointing

straight ahead and the throttle should be at an idle

position. Install the servo horn screws once the horns

have been centered. Use the trims on the radio to fine

tune the centering of the tires and the idle of the

engine. When finished trimming, turn the receiver and

transmitter off.

❏ 49. Locate the pre-drilled wing and place it onto the

wing support. Make sure that the holes in the wing line

up with the wing support. Place a tapered black plastic

washer over each of the two holes. Then insert a

3x12mm screw through the washer and wing into the

wing support. (Make sure not to overtighten the

screws holding the wing on to avoid stripping the

holes in the wing support).

❏ 50. Remove the plastic from the outside of the body.

Apply the decals if desired.

❏ 51. Remove the body clips from the parts bag.

Place the body onto the body mounts. On each body

mount place a body clip.

WING MOUNTING