Specifications

❏ 35. Snap the ball cup onto the throttle. Install a

second rod collar onto the throttle linkage so that it fits

against the rod connector. Note: Do not tighten the

set screw in the rod collar, the linkage will be

adjusted later.

❏ 36. Slide a 1/4" piece of fuel tubing over each of the

brake linkage rods. Then install a rod collar onto each

of the two rods. Note: Do not tighten the set screw

in the rod collars, the linkage will be adjusted later.

❏ 37. Locate the fuel tubing included with the kit. Cut

a 6" (150mm) piece to go from the fuel tank to the

carburetor and a 4" (100mm) piece to go from the fuel

tank to the pressure nipple on the tuned pipe.

❏ 38.Install one end of the 6" (150mm) piece of fuel

tubing onto the rotatable nipple on the rear of the fuel

tank and the other end onto the nipple on the carburetor.

❏ 39.Install one end of the 4" (100mm) piece of fuel

tubing onto the nipple next to the fuel tank lid and the

other end on the nipple on the tuned pipe.

❏ 40. Assemble the air filter. Slide the large rubber O-

ring around the threads of the outer housing. The O-

ring will help seal the air filter together.

❏ 41. Soak the air cleaner element with an air filter oil,

light machine oil, or in a pinch, shock oil (not included).

Thoroughly soak the foam element and squeeze out

the excess. Then install the filter element into the

plastic outer housing. Install the filter element into the

plastic outer housing.

AIR FILTER AND FUEL TUBING

INSTALLATION