Specifications

❏ 29. Remove the servo horn from the throttle servo.

Enlarge the two farthest holes at one end of the horn

and the farthest hole on the other end with a 5/64"

(2mm) drill or a hobby knife.

❏ 30. Install the rod connector into the top of the horn

at the end with the single enlarged hole. Apply a small

amount of thread locking compound onto the threads

of the rod connector, then thread on the 2mm nut. Do

not overtighten the nut, the rod connector must be

able to swivel freely.

❏ 31. Install the two linkage rods with the z-bends at

one end of them into the two enlarged holes at the

opposite end from the rod connector.

❏ 32. Install the set screw into two of the rod collars.

Place one rod collar onto both of the prebent linkage

rods. Note: Do not tighten the set screws all the

way down yet, the linkage will be adjusted later.

❏ 33. Re-install the servo horn onto the servo. Slide the

brake linkage rods through the brake levers as shown.

❏ 34. Screw the plastic ball cup onto the throttle

linkage wire. Install one rod collar onto the linkage rod,

then slide on the throttle linkage spring. Insert the

throttle linkage through the rod connector as shown.

Note: Do not tighten the set screw in the rod collar

down, adjustments will be made later.

Rod Connector