Specifications

5
5
12
STOP THE ENGINE
7
7
8
8
5
5
FUEL THE CAR START THE ENGINE
10
10
9
9
STOP THE ENGINE FAILSAFE
NR
ST
NR
TH
BIND
ST-D/RTH-TRIMST-TRIM
11
11
RE-BIND THE TRANSMITTER TO THE RECEIVER
See page 6 for starting
and engine break-in.
To stop your 835b engine,
place the pointed end of
the engine tool into the
exhaust outlet (stinger).
This will block the exhaust
and stop the engine.
Your radio system is
preset at the factory.
If you need to re-bind
your system, follow
these steps.
1. Insert bind plug into
receiver channel 3.
2. Move the radio
box switch to the
“ON” position.
The LED should
start blinking.
4. Move the radio box switch to the “OFF”
position and turn off the transmitter.
Remove the bind plug from the receiver.
3. Hold down the
transmitter’s “bind”
button and turn on
the transmitter. The
receiver LED will
stop blinking
To set:
1. Power up the transmitter and receiver.
2. Hold the buggy so the wheels are off the ground and clear
of all objects.
3. With the transmitter throttle in neutral, press the failsafe set
button on the receiver. The receiver LED will fl ash to indicate
a new failsafe point
has been set.
The R240FS receiver has a build in failsafe. If the
receiver loses contact with the transmitter, it will
automatically return the throttle to a preset point.
Failsafe Set
Button