Slim Ducted Installation Manual

DURASTAR.COM

WARNING

All wiring must be performed strictly in accordance with the wiring diagram located on

the inside of the control box lid.

3. Unscrew the cable clamp below the terminal block and place it to the side.

4. Feed the cable through the magnetic ring (some models) and secure the ring in place.

Magnetic ring

(if supplied with accessories)

1 2 3

Fix magnetic

ring around

cord

Choose the correct size of cable

The size of the outdoor power cable, signal cable, fuse, and switch needed is determined by the

maximum current of the unit. The maximum current is indicated on the nameplate located on the side

panel of the unit. Refer to this nameplate to choose the right cable, fuse, or switch.

Wiring the Indoor Unit

1. Prepare the cable for connection:

• Using wire strippers, strip the jacket from both ends of the cable to reveal about 6" of the

wires.

• Strip the insulation from the ends of the wires.

• Using a wire crimper, crimp u-lugs to the ends of the wires.

2. Open the control box lid of the indoor unit and locate the wiring diagram on the inside.

Wiring diagram

Control box

5. Refer to the wiring diagram and connect the u-lugs to the terminal block. Firmly screw the u-lug of

each wire to its corresponding terminal.

6. After checking to make sure every connection is secure, use the cable clamp to fasten the signal

cable to the unit. Screw the cable clamp down tightly.

7. Replace the control box lid.