Use and Care Manual

4. Slide front column right (FCRE) into groove of the the

front fase pallet (BPF) on the right side of the pallet. Line

up the pre-drilled holes on (FCRE) column with pre-drilled

holes on front base pallet. Secure with four (S5) screws

with (S6) washers from outside.

(See blowup detail fig.1)

BPF

FCRE

BPB

fig.1

FCRE

BPF

5. Assemble the center bands (CB2E) & (CB3SB) with (S3) screws

with nuts. Follow overlapping method shown below. Make two set.

For Center Band, Roof structure (RS3E) & (RS3SB).

Overlapping Method

Step 2

Step 3

Step 5

Step 4

5a. Add one (CB3SB) for each extension.

CB3SB

CB2E

CB3SB

CB2E

Step 1

Use a hammer to

align the holes.

TIP