Use and Care Manual

ManualsBrandsDuramax Building Products ManualsStorage & OrganizationYardmate 5 ft. x 8 ft. Storage Shed with Floor

1. Place the base pallet (BPF) on the ground with the

flat surface facing down.

A. Base, Walls & Columns

All panels are clearly marked and care should be

taken to use the correct one.

Note

Note: It is important that these instructions

are followed step by step.

Parts Needed:

(1) Base Pallet (BPF)

(2) Corner Column (CCE)

(1) Front Column Right (FCRE)

(1) Front Column Left (FCLE)

(1) Middle Column (CME)

(4) Side Panels (SPE )

(2) Side Center Band (CB2E)

(1) Back Center Band (CB2B)

(4) Center Band Fitting (FCB)

PART 1: Assembling Shed With Extension Kit

Parts Needed for each Extension

2. Remove the blind plug (BP) from the back side of

the base pallet. See fig.1

3. Assemble the base pallet (BPF) & (BPB) together using

base pallet plug (BPP). Locate the holes in the base pallet

(BPB) through the base pallet (BPF) and fix the base pallet

plug into position. Use a hammer (rubber Mallet) to drive in

base pallet pins (BPIN). Follow the steps (1 to 4).

TIP

BPF

fig.1

Step 1 Step 2

Step 3 Step 4

3a. For each extension add one basepallet (BPB)

from back side.

(1) Base Pallet (BPB)

(2) Middle Column (CME)

(2) Side Panels (SPE )

(2) Center Band (CB3SB)

(8) Base Pallet plug (BPP)

(8) Base Pallet pin (BPIN)

BPB

BPF

BPB

BPF

BPB

BPF

BPB

BPF

BPB

BPF

First insert all roof plugs with washers

then drive in the roof pins.