Owners Manual

1. Shed or shed foundation should be placed on
concrete footing by use of anchor bolt and nut.
Using a carpenters square, line up corners. Align
U-Channel base, mark the concrete through the
holes in the base and drill concrete with 1/2” (dia.
12.5mm) concrete bit to accept anchor bolts to a
1 3/4” (44mm) depth. Replace base and secure
with 1/4” x 1 1/2” (M6 x 40mm) anchor bolts.
See fig.
Note: To ensure that your shed withstands high winds,
you will need the following reinforcement.
29
High wind area installation instructions
Parts needed:
CODE DESCRIPTION QTY
S4 DIA. 4.2 x 16mm. (5/32” x 5/8”)
SHEET METAL SCREW 36
S5 M6 x 40mm. (1/4” x 1 1/2”)
Anchor bolt with nut 22
(not included with shed)
(not included with shed)
Concrete
Base U-channel
Anchor bolt & nut
Base U-channel
2. Attach each side panel (SP ) on the bottom to
the U-channel base. Using a dia. 3mm (1/8”) drill
with a power drill, make two equal distance holes
on the U-channel base through the side panel.
Drive a self tapping screw (S4) through the base
U-channel to the side panel. Repeat this for every
side panel. See blowup.
RS1
RS3
S4