User`s guide

-7-
3. Loading Ribbon and Vinyl Supply
3. Pull the cutter station down until it
rests, then push the gray print head
release buttons above the printer
carriage. The print head will spring
upward. Hold the ribbon so the loose
end falls to the rear of the printer,
then place one end of the ribbon on
the gray, spring loaded holder.
4. Place the other end of the ribbon
onto the holder on the other side
ensuring that the notches lock
into place.
5. Extend the ribbon around the print
carriage and use a small piece of
vinyl supply or tape to secure the
ribbon end on the empty rewind core.
6. Pull the ribbon snug by turning the
gray take-up wheel.
1. Open the Toro cover all the way
until it seats. Install a ribbon rewind
core onto the gray, spring-loaded
ribbon rewind holder on the top of
the print carriage.
2. Place the other end of the ribbon core
onto the holder on the other side.
Make sure to align the notch on the
holder with the notch on the core.
Loading Ribbon
Print head
release buttons
Ribbon Holders
Take-Up Wheel
Ribbon Rewind
Core Holders