User`s guide

-19-
Cutter Cleaning
1. Turn the printer power OFF.
2. Remove the screws on both sides of the manual cutter module.
3. Unplug the sensor connector and remove the cutter module.
4. Open a cleaning swab, and place the swab between your index nger and your thumb.
Squeeze the swab until it snaps. Alcohol will be distributed to the cotton side of the swab.
While pressing down on the cutter, run a cleaning swab back and forth several times
across the upper blade on of the back side of the cutter.
5. Run the cleaning swab back and forth several times across the upper blade on the front
side of the cutter.
11. Troubleshooting
For common print errors the Toro screen will prompt you with a graphic screen on the likely
cause of the error and what you can do to x it.