User`s guide

-8-
Loading Supply
1. Make sure the print carriage is in
the up position (gray buttons over
cutter station).
2. Place the label supply onto the supply
shaft and secure with the label xing
tabs on either side.
3. With the label supply extending over
the top of the spool toward the cutter
station, place the spindle into the
slots within the supply well. With the
DuraLabel supply label facing the
back of the printer.
4. Feed the end of the label supply
under the print carriage threading
it underneath the gray, adjustable
label guides.
5. Feed the supply through the print
carriage and thread the end through
the cutter station.
6. Adjust the gray guides toward the
edges of the supply, without binding.
7. Close the cutter mechanism by lifting
it up until it clicks into place.
8. Close the print carriage, then close
the Toro cover.
Adjustable
Label Guides
Cutter Station
Print Carriage
Fixing Tabs