User`s guide

7
800.788.5572 DuraLabel.com
LOADINg ThE PRINTER
E. Place the ribbon rewind spindle (with paper core) on the front hubs by inserting
the left side of the spindle first, fitting it onto the front spring-loaded hub. Then fit
the right (flanged) side of the spindle onto the right hub.
FIGURE 8 Ribbon supply (4.3") spindle inserted at rear hubs
FIGURE 7 Ribbon supply (4.3") spindle
being inserted at rear hubs
FIGURE 9 Ribbon rewind spindle with paper core (4.3") being applied to the front spring-loaded hub
FIGURE 10
Ribbon supply
(2.5") spindles
loaded and aligned
with each other
F. Open the printer cover by pulling the release levers on the sides of the printer
toward you.
FIGURE 11 Printer release lever being pulled forward