User`s guide

6
DuraLabel.com 800.788.5572
LOADINg ThE PRINTER
4.3 Loading Ribbon
Always turn the printer OFF when loading supplies. Always wait at least
5 seconds before turning power back ON.
Open the ribbon mechanism cover by pressing down and in to unlatch it, then lift it
up and back to open.
NOTE: To load 4.3" ribbon, follow “Loading 4.3" ribbon supply” instructions. To load
2.5" ribbon, follow “Loading 2.5" ribbon supply” instructions.
LOADING 4.3" RIBBON SUPPLY
A. With spindle flange on right side, load ribbon onto an empty ribbon supply
spindle, with the ribbon leader extended over the top and toward the back.
B. Slide the ribbon onto the spindle until it touches the spindle flange.
C. Apply the paper core to the other empty ribbon rewind spindle.
D. Apply the ribbon supply spindle to the rear hub, with the ribbon leader dropped
down. Insert the left side of the spindle first, fitting it onto the left hub, then fitting
the right (flanged) side onto the right hub.
FIGURE 1 Press down and in to unlatch. FIGURE 2 Lift up and back to open.
Ribbon Leader
Spindle Flange
FIGURE 3 Correct ribbon application for spindle