User`s guide

27
800.788.5572 DuraLabel.com
INSTALLINg DURASUITE LABELINg SOFTWARE
6.5 Adjusting Print Speed
Choose print speed from the Options tab, clicking
on the arrow to the right of the Print Speed
drop-down menu. A 2" per second setting is
recommended.
FIGURE 7 Printing Preferences
dialog box, with Options tab selected
RECOMMENDED DARKNESS SETTINGS FOR RIBBON: (PRINT SPEED SET AT 2)
Ribbon
Petroleum
Resistant
Standard
Black
White Red Blue Green Orange
Shrink
Tube/RTK
Die-Cut
Labels
Darkness 9-15 4-8 4-8 4-8 4-8 4-8 4-8 6-8 10-13
FIGURE 8 Adjust darkness settings to match your ribbon type and your printing needs.
When satisfied with all your settings, click Apply, then OK. Your driver is now set up
and ready to create labels.
NOTE: You may need to change print settings to optimize the DuraLabel PRO/PRO
300 for printing with some ribbons and specialty supply. Higher speeds generally
require higher densities. If a ribbon wrinkles, lower the darkness. Increase
darkness to ensure all ink is being transferred from the ink ribbon.
7. Installing DuraSuite Labeling Software
DuraSuite Labeling Software lets you create professional-quality pipe markers and
arc flash, RTK, NFPA Diamond, GHS and custom labels, quickly and easily.
Insert the DuraSuite Labeling Software installation CD in your computer’s disk drive
and follow the directions that appear on your screen. Refer to the DuraSuite Labeling
Software User’s Guide for additional information.
NOTE: You may need IT administrator privileges to perform this installation.
6.6 Adjusting Darkness
Change darkness settings from the Options tab, dragging the slider on the Darkness
bar (see Figure 7). Darkness can be adjusted in single increments from 0 – 15. Keep
the Graphics Format settings on Automatic.