User`s guide

CONFIgURINg PRINTER DRIvERS
25
800.788.5572 DuraLabel.com
6.2 Die-Cut Label Printing Instructions
6.2.1 LABEL SUPPLY CALIBRATION
Label supply must be calibrated to print die-cut labels.
A. With the power OFF, hold the Feed button down while turning ON the printer. The
LED will flash red 5 times, amber 5 times, green 5 times, alternating green and
amber 5 times, alternating red and amber 5 times and then turn solid green.
B. Release the Feed button while the LED blinks red and amber.
C. Follow directions in Section 6.2.2, Driver Settings.
6.2.2 DRIVER SETTINGS
Your printer driver has been preset to reduce the
number of steps to be completed manually. You can
change your settings by following these steps:
A. For die-cut labels, select Labels With Gaps from the
Type drop-down menu.
B. Set Gap Height to 0.12 inches and Gap Offset to 0
inches (default).
C. Click Apply, then OK.
FIGURE 3 Set the Printing Preference
Occurrence menu to “After Job” to print
multiple labels on a single length of supply.
FIGURE 2 Printing Preferences dialog box,
with Type set to “Continuous” and Occurrence
set to “After Every Page” on the Stock tab
FIGURE 4 Printing Preferences dialog
box, with Type set to “Labels With Gaps”