User`s guide
CONFIgURINg PRINTER DRIvERS
24
DuraLabel.com 800.788.5572
6. Conguring Printer Drivers
Perform the driver configuration before opening the document you
plan to print.
A. Click Start > Devices and Printers*. A Devices, Printers and Faxes window
appears.
*NOTE: If you do not nd Devices and Printers in your Start menu, you can access
it in your Control Panel.
B. Right-click the Graphic Products DuraLabel PRO/PRO 300 icon and select
Printing preferences. A Printing Preferences dialog box appears.
C. Click the Page Setup tab and select Landscape or
Portrait, depending on your label’s orientation.
D. If your label size is not shown in the Stock Name
drop-down menu, click Edit and set the size that
matches your label size.
NOTE: Your DuraLabel PRO/PRO 300 print drivers are
preset to several print values. Please be aware that
changing a preset value is not fully supported by all
software programs. For best results, make changes to
preset values from the Devices and Printers window.
6.1 Continuous Vinyl Printing Instructions
Your printer driver has been preset to common settings to reduce the steps needed
to set them manually. You can change your settings by following these steps:
A. To configure the driver, set the cutter, select the Stock tab, then select
Continuous from the Type drop-down menu under “Media Settings.”
B. To cut after each label, select Cut from the Post-Print Action drop-down menu
and select After Every Page from the Occurrence drop-down menu.
C. To cut after each job, select Cut from the Post-Print Action drop-down menu and
select After Job from the Occurrence drop-down menu.
D. Click Apply, then OK.
These settings may be adjusted in Printer Properties* when printing your labels.
*NOTE: This will show as Preferences if accessing File > Print from DuraSuite
Labeling Software.
FIGURE 1 Printing Preferences dialog
box with Page Setup tab selected