User`s guide

800.788.5572 DuraLabel.com

CONNECTINg ThE PRINTER

5. Connecting the Printer

Connect the power supply from the DuraLabel PRO/PRO 300 printer to an electrical

outlet. Next, connect the USB or parallel cable from the DuraLabel PRO to your PC,

then power ON your printer.

5.1 Inserting the Installation CD

Before inserting the installation CD, please refer to the specific instructions for the

type of cable you’re using. When using a USB cable, follow instructions in Section

5.2, Using a USB Cable. When using a parallel cable, follow instructions in Section

5.3, Using a Parallel Cable.

NOTE: When printing RTK, arc ash and other die-cut or B Mark labels, you must

set up the print driver and printer. Refer to Section 6.2, Die-Cut Label Printing

Instructions, or Section 6.3, B Mark Label Printing Instructions.

5.2 Using a USB Cable

NOTE: You may need IT administrator privileges to install a driver.

NOTE: The following instructions are only for those using a USB cable. Skip to

Section 5.3, Using a Parallel Cable, if installing manually.

A. Insert the DuraLabel PRO or DuraLabel

PRO 300 Installation CD in your

computer’s disk drive. A DuraLabel

PRO/PRO 300 startup screen appears.

NOTE: If the CD does not run

automatically, go to Start > Computer and

double-click on your CD/DVD drive, which

should show the DLP icon.

B. Click on Driver Wizard, then click Next

in the Driver Wizard setup window that appears.

FIGURE 1 DuraLabel PRO 300 startup screen

FIGURE 2 DuraLabel Driver Setup Wizard