User`s guide

10
DuraLabel.com 800.788.5572
LOADINg ThE PRINTER
4.4 Loading Vinyl Supply
Always turn the printer OFF when loading supplies. Always wait at least
5 seconds before turning power back ON.
A. Load the vinyl supply onto the label supply spindle, centering and securing it with
the fixing tabs located on each end.
B. Place loaded label supply spindle into the label roll mount slots, with the label
supply extending over the top of the roll and toward the front of the printer.
FIGURE 1 Loaded label supply spindle set in label
roll mount slots
C. Lead the label supply underneath the
white Teflon bar, over the platen roller
and through the printed label opening,
leaving at least ½" of supply extended
out to help prevent loading errors.
D. Move the adjustable label guides to hold the label supply in place.
FIGURE 2 Label supply loaded in the correct direction
FIGURE 3 Label supply loaded correctly, with printable
surface facing up and liner facing down
FIGURE 4 Label supply held in place by adjustable label
guides