Specifications

8.2 Button Operation
Feed Press the button when the LED is green. 

 It feeds the label to the beginning of the next label.
Pause
Press the feed button during printing.
 The printing job is suspended.
Ribbon Sensor
Calibration
Turn off the power switch and wait 5 seconds.
Press the button while turning on the power switch.
Release the button when LED blinks red.
 It will calibrate the ribbon sensor sensitivity.
Gap/Black Mark Sensor
Calibration, Label
Length Measurement,
Self Test and Enter
Dump Mode



Turn off the power switch and wait 5 seconds.
Hold down the button while turning on the power switch.
Release the button when LED blinks orange.
 The LED color will flash as follows:
Orangered (5 blinks)orange (5 blinks)
green (5 blinks)solid green.
 It calibrates the sensor, measures the label length
and prints internal settings then enters the dump mode.
Printer Initialization
Turn off the power switch and wait 5 seconds.

Hold down the button while turning on the power switch.

Release the button when LED turns green after 5
orange blinks.
 The LED color will flash as follows:
orangered (5 blinks)orange (5 blinks)
green (5 blinks)solid green.

Always do gap/black mark sensor calibration after
printer initialization when printing on die-cut labels.
19