Specifications

4.3 Initialization

Printer initialization is used to clear DRAM and restore printer settings to

defaults. The only one exception is ribbon sensitivity, which will not be restored

to default.

Printer initialization is activated by the following procedures.

1. Turn off printer power and wait 5 seconds.

2. Press the FEED button and then turn on power. The LED will blink five times

per color (red, orange, green).

3. Release the FEED button when the LED blinks green.

The LED color will be changed as following pattern:

Orange red (5 blinks) orange (5 blinks) green (5 blinks) solid green

4. Printer configuration will be restored to defaults as below after initialization.

Parameter Default setting

Speed 2 in. per second

Density 5

Label Width 4 in.

Label Height 6 in.

Sensor Type Gap sensor

Gap Setting 0.12 in. (3.0 mm)

Print Direction 0

Reference Point 0,0 (upper left corner)

Offset 0

Tear Mode On

Peel off Mode Off

Cutter Mode Off

Serial Port Settings

9600 bps, none parity, 8 data bits, 1 stop

bit

Code Page 850

Country Code 001

Clear Flash Memory