User`s guide

- 7 -
7
4
6
5
2
3
1
1. USB
2. Centronics
3. RS-232
4. Power Switch
5. Power Cable
6. Power Supply
7. Plug
2. CONNECT PRINTER
**IMPORTANT** These Steps need to be done in the order below!
1. Connect the power supply.
2. Connect the DuraLabel PRO 300 to your PC using the USB or parallel
cable.
3. Turn on the DuraLabel PRO 300.
(Switch is in back of printer, See Figure 6)
3. INSTALL USING USB CABLE
**IMPORTANT**
You must have administrative rights in order to perform this installation.
1. A “Found New Hardware” dialog box may appear. If so, select “No, at this
time.”
2. Insert DuraLabel PRO 300 Installation CD into the CD-ROM drive.
3. Select “Install the software automatically” and click “Next.”
(Step 3 of "Install Using USB Cable" may run automatically.)
4. When pr
ompted to continue, click “Continue Anyway.”
5. A dialog will appear showing the installation progress and will close after
completion.
6. A Found New Hardware dialog box will appear, click “Finish” to exit and to
close the window.
7. Skip to page 9, Step “5. Set up to Print.”
Figure 6