User`s guide

- 6 -
Load Vinyl Tape
**IMPORTANT** Always turn OFF the power first!
1. With the Ribbon Mechanism still in upright position, center the Label
Stock on the Label Supply Roll Spindle using the Fixing Tabs.
(See Figure 4)
2. Place the Label Supply Spindle with the Label Stock in the Label Roll
Mount slots.
(See Figure 5)
3. Guide the Label Stock underneath the white Teflon Bar.
4. Secure the Label Stock in place by moving the Adjustable Label Guides to
hold the Label Stock in the center.
5. Thread the Label Stock through the Printed Label Opening, leaving about
1/2" Label Stock hanging out the opening.
6. Close Printer Cover by lifting it all the way up, then gently press down until it
latches closed.
7. Close the Ribbon Mechanism Cover by pressing down until it latches.
Printer Cover
Adjustable Label
Guides
Top Cover Support
Printer Cover
Release Lever
White Tefl on Bar
Label Roll Mount
Print Head
(metal bar underneath)
Printing Side
Face Up
Label Supply Spindle
Fixing Tab
Vinyl Tape
Figure 4
Figure 5