User`s guide

4. Apply the provided paper core onto the front Ribbon Rewind Spindle.
5. Skip to Step 6, section Load Ribbon Continued. (See page 7, section “Load
Ribbon Continued”)
To Load 2.5" ribbon supply
2. With the flange of the spindle on the right side, apply 2.5" Ribbon Supply to the
Front Ribbon Spindle with the Ribbon Supply leader extended over the top and
towards the back.
3. Align the 2.5" Ribbon Supply in the center of the ribbon spindle using the
measurement marks.
4. Apply the provided 2.5" paper core onto the front Ribbon Rewind Spindle and
center it using the measurement marks.
5. Skip to Step 6, section Load Ribbon Continued. (See page 7, section “Load
Ribbon Continued”)
Fig. 4 Ribbon Supply (2.5")
centered on Ribbon
Supply Spindle
Fig. 5 Paper core (2.5")
centered on Ribbon
Supply Spindle
Ribbon leader
Flange of Spindle
Fig. 3 Correct ribbon application for Spindle
-6-