User`s guide

Load Ribbon
IMPORTANT! Always turn OFF the printer when loading supplies. Always wait at
least 5 seconds before turning ON the power.
The ribbon and various print media for the DuraLabel
®
LabPRO have been optimized for
compatibility and print quality. Only authorized supplies from Graphic Products will print
correctly in the DuraLabel
®
LabPRO.
Turn the power OFF first!
1. Open the Ribbon Mechanism Co
ver by pressing down and in on the Ribbon
Mechanism Cover to unlatch, then lift up and back to open.
For loading 4.3" ribbon supply, please follow "To Load 4.3" ribbon supply"
instructions (page 5). F
or loading 2.5" ribbon supply, please follow "To Load 2.5"
ribbon supply" instructions (page 6).
To Load 4.3" ribbon supply
2. With flange of the spindle on the right side, apply 4.3" Ribbon Supply t
o the
Ribbon Supply Spindle with the Ribbon Supply leader extended over the top and
towards the back.
3. Slide the Ribbon Supply on the Spindle until it touches the Flange of the Spindle.
Fig. 1 Press down and in to unlatch
Fig. 2 Lift up and back to open
Ribbon leader
Flange of Spindle
Fig. 3 Correct ribbon application for Spindle
-5-