User`s guide

4. SYMPTOM: When using die-cuts, printing stops shortly after starting print
job and LED blinks red.
Possible Cause: Gap sensor has not been initialized.
Solution:
1. Power OFF the printer and wait 5 seconds.
2. Hold the FEED button while powering back ON the printer.
3. Continue to hold FEED until the light flashes red, then release.
NOTE:
Printer will dispense blank label stock as a result. (See pages 12-13 of Printer's Manual)
5. SYMPTOM: After printing a label the LED blinks green.
Possible Cause: FEED button was pressed during printing.
Solution: Press the FEED button again to resume printing.
6. SYMPTOM: After printing a label, printer dispenses extra label stock and LED
blinks red.
Possible Cause: The printer is set to print on "labels with gaps," even though
stock being used is continuous feed.
Solution:
1. Open the Printers and Faxes folder.
2. Right-click on the Graphic Products DuraLabel
®
LabPRO.
3. Select "Printing Preferences."
4. Click the STOCK tab.
5. Under "Media Settings" change "Type" to "Continuous."
6. Click "Apply" then "OK."
(See pages 25-27 of User's Guide)
7. SYMPTOM: The print and cut are off the mark, when using die-cut stock.
Possible Cause: Print driver is set to print on continuous-feed tape even though
the label stock has gaps between labels.
Solution:
1. Open the Printers and Faxes folder.
2. Right-click on the Graphic Products DuraLabel
®
LabPRO.
3. Select "Printing Preferences."
4. Click the STOCK tab.
5. Under the "Media Settings" change "Type" to "Labels with Gaps."
6. Click "Apply" then "OK." (See page 25 of User's Guide)
-56-