User`s guide

Cleaning The Cutter From The Inside
As an option you may also remove the cutter from the printer to effi ciently clean both sides of
the cutting blades.
1. Gently but fi rmly, lift the cutting mechanism out of the printer with both hands.
Wires will still be connected, so avoid pulling cutting mechanism too hard or too far
from the printer. Doing so may damage wire connections.
2. Open a cleaning swab and place the swab between your forefi nger and thumb.
Squeeze swab until it snaps. Alcohol will be distributed to the cotton side of the
swab.
3. Run the swab back and forth several times across the cutter to remove any buildup
of labeling adhesive. Wait a few seconds for any alcohol to dry.
4. Replace the cutting mechanism by inserting tabs on the sides of the cutter into
slots on printer as shown in the photo.
Fig. 5 Cutter Removed (fi t the tab on the side of the cutter back in the provided slot)
Be sure to place the wires back into the open slot they are connecting from. Do not allow the
wires to get pinched when put back together.
NOTE
-52-