User`s guide

Cut Labels in Intervals
To cut labels in intervals, you may do
so by setting the “Occurrence” to After
Specified Interval under the Stock
Tab. Set the Interval to the number of
labels needed. Click Apply to save your
settings.
Adjust Print Speed
Print Speed is adjustable from 2.0" to 3.0"/sec. Choose the print speed from the
Option Tab by clicking on the arrow to the right of the “Print Speed” box.
Adjust Darkness
The Darkness is adjusted from 0 to 15 in incre-
ments of 1. From the Option Tab, change the
darkness by clicking on and dragging the slider
on the “Darkness” bar.
The Graphics Format settings should not be
adjusted. Leave them at Automatic.
When finished with your settings, click Apply
then click OK.
Your driver is now set up and you are ready to create your labels!
In certain situations, you may need to change the print settings to optimize the DuraLabel
®
LabPRO for printing with certain ribbons or a specialty tape supply. Generally, higher speeds
require higher densities. If the ribbon wrinkles, lower the darkness. Increase the Darkness
to prevent fading. Decrease to prevent wrinkling.
NOTE
-27-