User`s guide

Continuous Vinyl Printing Instructions
To set the cutter, select the Stock
Tab. Set the Media Settings “Type” to
Continuous. In order for the automatic
cutter to cut after each label, under
Media Handling next to “Post-Print
Action,” select Cut and then next to
“Occurrence” select After Every Page.
These settings may be later adjusted
to your specifications in the Printer
Properties as you are printing your
labels. Select Apply on the bottom of
the Printing Preferences window.
Die-Cut Label Instructions
Die-Cut Label Calibration
In order to print die-cut labels, the label
stock needs to be calibrated. To do so,
with the printer power OFF, hold the FEED
button down while turning ON the printer.
Release the FEED button while it blinks
red. Once this process is complete follow
the "Driver Settings for Die-Cut Labels" to
change the driver settings.
Driver Settings for Die-Cut Labels
For die-cut labels with the 1/8" gap, the settings on the Stock tab should be as
follows: “Method” set to Thermal Transfer, the “Type” set to Labels With Gaps, “Gap
Height” set to 0.12 (default) and “Gap Offset” to 0 (default.)
-25-