User`s guide

4. Remove the outside supply guide from the supply bar and set aside.

5. Adjust the inside supply guide to cover the number corresponding to the size of

vinyl supply being loaded.

(see Figure 4 & 5)

6. Place the vinyl supply onto the supply bar.

NOTE: The vinyl supply should roll over the top and towards the front of the printer.

7. Fit the outside supply guide onto the label bar, against the vinyl supply, but with

enough room for the vinyl supply to rotate with ease.

Supply Guide

Fig. 4 The inside supply guide is set

or 6" vinyl supply/media

Fig. 5 The inside supply guide is set

for 8" vinyl supply/media

Supply Bar

Fig. 3 Both Supply Guides still on Supply Bar

Supply Guides

Supply Bar

Vinyl Supply/Media

Fig. 6 Vinyl loaded with outside Supply Guide applied to Supply Bar

-7-