User`s guide

Cut Labels in Intervals
To cut labels in intervals, you may do so by
setting the “Occurrence” to After Specified
Interval under the Stock Tab. Set the
Interval to the number of labels needed.
Click Apply to save your settings.
Adjust Print Speed
Print Speed is adjustable from 2.0" to 3.0"/
sec. Choose the print speed from the
Option Tab by clicking on the arrow to the
right of the “Print Speed” box.
Adjust Darkness
The Darkness is adjusted from 0 to 15 in
increments of 1. From the Option Tab,
change the darkness by clicking on and
dragging the slider on the “Darkness” bar.
The Graphics Format settings should not
be adjusted. Leave them at Automatic.
When finished with your settings, click Apply then click OK.
Your driver is now set up and you are ready to create your labels!
In certain situations, you may need to change the print settings to optimize the DuraLabel
®
9000 for printing with certain ribbons or a specialty tape supply. Generally, higher speeds
require higher densities. If the ribbon wrinkles, lower the darkness. Increase the Dark-
ness to prevent fading. Decrease to prevent wrinkling.
NOTE
Recommended Darkness and Print Speed Settings:
Ribbon Chemical
Standard
Black
White Red Blue Green Orange
Shrink
Tube
Die-Cut
Labels
Darkness - 4-6 4-6 4-6 4-6 4-6 4-6 - 8
Speed 2 2 2222 2 2 2
-25-