User`s guide

Black Mark Label Instructions
Black Mark Calibration
In order to print labels with black marks, the label stock needs to be calibrated. To
do so, from the DuraLabel 9000 Control Panel select Menu >>> Setup >>> Printer
Setup >>> Sensor >>> Calibration >>> Bmark Mode >>> Automatic. Once this
process is complete follow the "Driver Settings for Black Mark Labels" to change the
driver settings.
Driver Settings for Black Mark Labels
For black mark labels with the 1/8" black mark, the settings on the Stock tab should
be as follows: “Method” set to Thermal Transfer, the “Type” set to Labels With
Marks, “Mark Height” set to 0.12 (default) and “Mark Offset” to 0 (default.)
You can adjust where the printer cuts to make sure the cut is directly centered on the
black mark by adjusting the Feed Offset in the Stock tab of the Printer Properties.
NOTE
-24-