User`s guide

Media Sensor Adjustment for RTK Color Bar Die-Cut Labels
For RTK Color Bar Die-Cuts which have a blank printable-area at the top, the media
sensor should be adjusted so that it is centered over the printable-area (blank white
section of label) at the top of the RTK Color Bar die-cut label.
To do so, slide the Media Sensor until the end of the Media Sensor is located over the
the printable-area of the RTK Color Bar label.
Correct:
Fig. 10 End of Media Sensor centered over printable-area of RTK Color Bar Die-Cut
label
-23-