User`s guide

Media Sensor Adjustment for Die-Cut Labels with Headers
For optimum printing using the various die-cut labels, the media sensor needs to be
adjusted either to the right or left.
For Die-Cuts with a pre-printed header at the top of the label, such as Arc Flash, Dan-
ger, and Notice Die-Cut labels, the media sensor should be adjusted so that the end
is centered over the printable area (blank, white printable-area of label)
To do so, slide the Media Sensor until the end of the Media Sensor is located over the
white printable-area of the die-cut label.
Correct: Incorrect:
Fig. 2 End of Media Sensor Not
centered over printable-
area of die-cut label
Fig. 1 End of Media Sensor centered
over printable-area (white
section of label)
Media Sensor
-22-