User`s guide

Continuous Vinyl Printing Instructions
To set the cutter, select the Stock
Tab. Set the Media Settings “Type” to
Continuous. In order for the automatic
cutter to cut after each label, under
Media Handling next to “Post-Print
Action,” select Cut and then next to
“Occurrence” select After Every Page.
These settings may be later adjusted
to your specifications in the Printer
Properties as you are printing your
labels. Select Apply on the bottom of
the Printing Preferences window.
Die-Cut Label Instructions
Die-Cut Label Calibration
In order to print die-cut labels, the label stock needs to be calibrated. To do so, from
the DuraLabel 9000 Control Panel select Menu >>> Setup >>> Printer Setup >>>
Sensor >>> Calibration >>> Gap Mode >>> Automatic. Once this process is com-
plete follow the "Driver Settings for Die-Cut
Labels" to change the driver settings.
Driver Settings for Die-Cut Labels
For die-cut labels with the 1/8" gap, the set-
tings on the Stock tab should be as follows:
“Method” set to Thermal Transfer, the “Type”
set to Labels With Gaps, “Gap Height” set
to 0.12 (default) and “Gap Offset” to 0
(default.)
You can adjust where the printer cuts to make sure the cut is directly centered in the gap
by adjusting the Feed Offset in the Stock tab of the Printer Properties.
NOTE
-21-