User`s guide

Fig. 2 Empty supply core applied to front Ribbon Rewind Spindle
Load Ribbon
IMPORTANT! Always turn OFF the printer when loading supplies. Always wait at
least 5 seconds before turning ON the power.
Turn printer power OFF first!
1. Set the ribbon guides on the ribbon spindles based on the size of ribbon loaded.
a. F
or 4.33" ribbon, move each ribbon guide to the line indicated on the label
on the ribbon spindles and tighten the screw on the top of each of the ribbon
guides.
b. For 8.66" ribbon, move the ribbon guides against the inside wall of the printer.
2. Slide an empty supply core onto the front ribbon rewind spindle.
NOTE: Make sure the empty supply core is flushed against the ribbon guide.
Ribbon Rewind
Spindle
Ribbon Spindle
-10-