User`s guide

3.5 Service
Service
Initialization Mileage Info. Exit
This feature is used to restore printer settings to defaults and display printer mileage
information.
3.5.1 Initialization
Service 1/3 Initialization Initializing ...
> Initialization
Mileage Info. SELECT YES
Exit MENU NO
The printer settings are restored to defaults as below once printer is initialized.
Note : When printer initialization is done, please calibrate the gap or black-mark
sensor before printing supplies with gap or black-mark sensor.
Parameter Default setting
Speed
2 IPS (50.8 mm/sec)
Density
5.0
Label width
9"(219.5mm)
Label length
15"(101.6mm)
Sensor type
Gap sensor
Gap setting
0.12"(3.0mm)
Print direction
0
Reference point
0,0(upper left corner)
Offset
0
Print mode
Batch mode
Serial port settings
9600 bps, none parity, 8 data bits, 1 stop bit
Code page
850
Country code
001
Clear flash memory
No
Shift X
0
Shift Y
0
Gap sensor sensitivity
3 (Will be reset. Need to re-calibrate the gap)
Bline sensor sensitivity
2 (Will be reset. Need to re-calibrate the gap)
Language
English
IP address
DHCP
42