User`s guide

Gap Size
0024 dot
2. Press to move the cursor
from left digit to right digit, and press
to set the value from “0” to “9”
and the “dot/ mm/ inch”. Press
to set the gap size into the
printer.
Gap Mode
Scan Backing
Intensity x
Ref. Level xxx
3. Open the print head mechanism and
put the label backing (liner) under the
media sensor. Press
to
set the value into the printer.
Gap Mode
Scan Paper
Intensity x
Ref. Level xxx
4. Then, put the label with liner under the
media sensor. Press
to
set the value into the printer.
Gap Mode
Complete
Intensity x
Ref. Level xxx
5. The gap sensor calibration is
complete. Press
; the LCD
screen will return to the previous
menu.
A-3 Pre-Printed
This function can set the paper length and gap size prior to auto-calibration
of the sensor sensitivity. It will set the sensor sensitivity accurately.
25
When entering [Pre-Printed] option, you will see following message. Please
complete these steps:
Paper Len.
00812 dot
1. Press to move the cursor
from left digit to right digit, and press
button to set the value from
“0” to “9” and the “dot/ mm/ inch”.
Press
to set the paper
length into the printer.
Gap Size
0024 dot
2. Press to move the cursor
from left digit to right digit, and press
to set the value from “0” to “9”
and the “dot/ mm/ inch”. Press
to set the gap size into the
printer.
Gap Mode 3/4
Manual
> Pre-Printed
Exit