User`s guide

to enable the setting. Press to cancel.

The following 2 figures are the printouts of DIRECTION 0 and 1 for your reference.

DIRECTION 0 DIRECTION 1

Note: If printing from enclosed software/driver, the software/driver will send

out the command, which overwrites the setting entered from the front

panel.

3.1.1.4 Print Mode: (None/Batch Mode/Peeler Mode/Cutter Mode/Cutter Batch)

Print Setup 4/12

Density

Direction

> Print Mode

Print Mode 2/6

> Batch Mode

Peeler Mode

Cutter Mode

This option is used to set the print mode. Printer default setting is Batch Mode.

When entering this list, the print mode in the right side of " >" icon is the printer

current setting. Press

or to select the different print mode and

press

to enable the setting. Press to cancel.

Printer Mode Description

None

Next label is aligned to the print head burn line location. (Tear

Off Mode)

Batch Mode

Once image is printed completely, label gap/black-mark will be

fed to the tear plate location for tear away.

Peeler Mode Enable the label peel off mode.

Cutter Mode Enable the label cutter mode.

Cutter Batch Cut the label once at the end of the printing job.

Note: If printing from enclosed software/driver, the software/driver will send out the

command, which overwrites the setting set from the front panel.