User`s guide

40
DuraLabel.com 800.788.5572
CLEANING AND GENERAL MAINTENANCE
11.2 Cutter
A. Open the DuraLabel 9000 cover.
B. Rewind any loaded supply away
from the cutting mechansim.
C. Using a magnetic screwdriver,
remove the two recessed screws
on the front of the cutting
mechanism.
D. Lift up the cutting mechansim
slightly and pull it away from the
printer body.
E. Place a cleaning swab between
your forefinger and thumb and
squeeze until it snaps. Alcohol will be
distributed to the cotton side of the
swab.
FIGURE 5 Remove the recessed screws, shown inside the circles.
FIGURE 6 Detached cutter mechanism, exposing
cutting blades
FIGURE 7 Cutting blades at the printed label opening
F. Run the swab back and forth several
times across all sides of the cutting
mechanism’s cutting blades to
remove any buildup of labeling
adhesive.
G. Attach the cutting mechanism to the
front of the printer and tighten the
screws.
FIGURE 8 Cleaning blades inside cutter mechanism