User`s guide

35
800.788.5572 DuraLabel.com
CONFIGURING ETHERNET CARD
10. Conguring Ethernet Card
The internal Ethernet card can be configured using the front display panel buttons
and LCD on the DuraLabel 9000.
The Menu button on the front display panel will provide access to the printer menu.
Use the UP and DOWN buttons to navigate through the menu. To enter data, use the
UP button to increment the highlighted digit by 1. The DOWN button will shift one
over and highlight the next digit. Pressing SELECT will accept the selection. Pressing
MENU will take you to the previous screen.
10.1 Setting an Ethernet Port using the Diagnostic Tool
Use the following steps to set a port with the diagnostic tool:
A. Open My Computer, then right-click on the DuraLabel 9000 disk icon and select
Open.
B. Double-click on the DiagTool_128.exe to run the tool.
C. Click on Ethernet Setup from the Printer Function buttons on the left side.
D. On the Ethernet Setup window, select DHCP or set a specific Static IP, Subnet
Mask and Gateway. Click Set IP. The printer will restart with the new settings.
10.2 Installing a Driver for the Ethernet Port
Follow these steps to install a driver for use
with the Ethernet port:
A. Insert the DuraLabel 9000 Installation CD
in your computer’s disk drive. A DuraLabel
9000 startup screen appears.
B. Click on Driver Wizard, then click Next
on the Driver Setup Wizard window that
appears.
C. Click I Agree on the Windows Printer Driver
License Agreement window that appears.
FIGURE 1 DuraLabel 9000 Startup Screen
FIGURE 2 DuraLabel Driver Setup Wizard FIGURE 3 Windows Printer Driver License
Agreement