User`s guide

23
800.788.5572 DuraLabel.com
CONFIGURING PRINTER DRIVERS
6.3.3 ADJUSTING THE B MARK MEDIA SENSOR
To ensure the media sensor is correctly
positioned, check the position of the mark
on the back of the B Mark supply, then, if
necessary, adjust the media sensor to ensure
it is positioned under the supply mark.
6.3.2 DRIVER SETTINGS
Your printer driver has been preset to reduce the number of steps to be completed
manually. You can change your settings by following these steps:
A. For B Mark labels, select Labels With Marks from the
Type drop-down menu.
B. Set Mark Height to 0.12 inches and Mark Offset to
0 inches (default).
C. Click Apply, then OK.
NOTE: Ensure the printer cuts correctly on B Mark
labels by adjusting Feed Offset on the Printing
Preferences dialog box Stock tab. The 0 default setting
works best for most label supply.
FIGURE 10 Printing Preferences
dialog box, with Type set to “Labels
With Marks” on the Stock tab
FIGURE 13 Printing Preferences dialog
box, with Occurrence set to “After Specied
Interval” on the Stock tab
FIGURE 11 If the printer does not cut a B Mark
label accurately, adjust Feed Offset up or down.
FIGURE 12 Align the media sensor (circled) under your supply,
ensuring it is in sight of the B Mark for proper alignment.
Media Sensor
6.4 Cutting Labels in Intervals
To cut labels in intervals, set “Occurrence” to After
Specified Interval. Set the interval to the number of labels
needed, then click Apply to save your settings.