User`s guide

22
DuraLabel.com 800.788.5572
CONFIGURING PRINTER DRIVERS
6.2.4 MEDIA SENSOR ADJUSTMENT FOR RTK COLOR BAR DIE-CUT LABELS
For RTK color bar die-cuts with a blank printable area at the top, the media sensor
should be adjusted so it’s centered over the label’s printable area. Slide the media
sensor until its end is located over the blank white printable area.
6.3 B Mark Label Printing Instructions
6.3.1 LABEL SUPPLY CALIBRATION
Label supply must be calibrated to print B Mark labels. Using the menu on the left
side of the front of your printer, follow these steps:
A. Press the Menu button.
B. Select Setup.
C. Select Sensor.
D. Select Calibration.
E. Select B Mark Mode.
F. Select Automatic.
G. The printer will begin to feed supply as it calibrates.
H. Follow directions in Section 6.3.2, Driver Settings.
FIGURE 9 End of media sensor centered over RTK color bar label printable area
CORRECT