User`s guide

21
800.788.5572 DuraLabel.com
CONFIGURING PRINTER DRIVERS
NOTE: Ensure the printer cuts directly in the center
of the gap by adjusting Feed Offset on the Printing
Preferences dialog box Stock tab. The 0 default
setting works best for most label supply.
6.2.3 MEDIA SENSOR ADJUSTMENT FOR DIE-CUT LABELS WITH HEADERS
For optimum printing on die-cut labels, the media sensor needs to be adjusted either
to the right or left.
For die-cuts with a pre-printed header at the top – such as arc flash or NFPA labels –
the media sensor should be adjusted so the end is centered over the blank printable
area of the label. Slide the media sensor until its end is located over the blank white
printable area.
FIGURE 4 Printing Preferences dialog
box, with Type set to “Labels With
Gaps” on the Stock tab
FIGURE 5 If the printer does not cut
correctly, adjust Feed Offset up or down.
FIGURE 8 End of media sensor not centered over
printable area
CORRECT INCORRECT
FIGURE 7 End of media sensor centered over printable area
(white section of label)
FIGURE 6 DuraLabel 9000 adjustable media sensor
Media Sensor