User`s guide

20
DuraLabel.com 800.788.5572
CONFIGURING PRINTER DRIVERS
These settings may be adjusted in Printer Properties* when printing your labels.
*NOTE: This will show as Preferences if accessing File > Print from DuraSuite
Labeling Software.
6.2 Die-Cut Label Printing Instructions
6.2.1 LABEL SUPPLY CALIBRATION
Label supply must be calibrated to print die-cut labels. Using the menu on the left
side of the front of your printer, follow these steps:
A. Press the Menu button.
B. Select Setup.
C. Select Sensor.
D. Select Calibration.
E. Select Gap Mode.
F. Select Automatic.
G. The printer will begin to feed supply as it calibrates.
H. Follow directions in Section 6.2.2, Driver Settings.
6.2.2 DRIVER SETTINGS
Your printer driver has been preset to reduce the number of steps to be completed
manually. You can change settings by following these steps:
A. For die-cut labels, select Labels With Gaps from the Type drop-down menu.
B. Set Gap Height to 0.12 inches and Gap Offset to 0 inches (default).
C. Click Apply, then OK.
FIGURE 2 Printing
Preferences dialog
box, with Type set to
“Continuous” and
Occurrence set to
“After Every Page” on
the Stock tab
FIGURE 3 Set the
Printing Preferences
Occurrence menu to
“After Job” to print
multiple labels on
a single length of
supply.