User`s guide

13
800.788.5572 DuraLabel.com
CONNECTING THE PRINTER
5. Connecting the Printer
Connect the power supply from the DuraLabel 9000 printer to an electrical outlet.
Connect the USB or parallel cable from the DuraLabel 9000 to your PC and power
ON the printer.
5.1 Inserting the Installation CD
Before inserting the installation CD, refer to the instructions for the type of cable
you’re using. When using a USB cable, follow instructions in Section 5.2, Using a
USB Cable. When using a parallel cable, follow instructions in Section 5.3, Using a
Parallel Cable.
NOTE: When printing RTK, arc ash and other die-cut or B Mark labels, you must
set up the printer driver and printer. Refer to Section 6.2, Die-Cut Label Printing
Instructions, or Section 6.3, B Mark Label Printing Instructions.
5.2 Using a USB Cable
NOTE: You may need IT administrator privileges to install a driver.
NOTE: The following instructions are only for those using a USB cable. Skip to
Section 5.3, Using a Parallel Cable, if installing manually.
A. Insert the DuraLabel 9000 Installation CD in
your computer’s disk drive. A DuraLabel 9000
startup screen appears.
NOTE: If the CD does not run automatically, go to
Start > Computer and double-click on your CD/
DVD drive, which should show the DLP icon.
B. Click on Driver Wizard, then click Next in the Driver Wizard window that appears.
C. Click I Agree on the Windows Printer Driver License Agreement window that
appears.
FIGURE 1 DuraLabel 9000 Startup Screen
FIGURE 2 DuraLabel Driver Setup Wizard
FIGURE 3 Windows Printer Driver License
Agreement