User`s guide

10
DuraLabel.com 800.788.5572
LOADING THE PRINTER
4.5 Loading Ribbon
Always turn the printer OFF when loading supplies. Always wait at least
5 seconds before turning power back ON.
A. Set ribbon spindle guides based on loaded ribbon size.
a. For 4.33" ribbon,
move each ribbon
guide to the line
indicated on the
ribbon spindle
and tighten the
screw on the top
of each ribbon
guide.
b. For 8.66" ribbon, move the ribbon guides against the inside printer wall.
B. Slide an empty supply core onto the front ribbon rewind spindle.
NOTE: Make sure the empty supply core is ush against the ribbon guide.
FIGURE 1 Guides for 4.33" ribbon
FIGURE 2 Guides for 8.66" ribbon
FIGURE 3 Empty supply core applied to front ribbon rewind spindle
Ribbon Rewind Spindle
Ribbon Spindle