User`s guide

- 7 -
Load Ribbon Supply
1. Set the ribbon guides based on the size of ribbon loaded.
a. For 4.33" ribbon, move each ribbon guide to the line indicated on the label
on the ribbon spindles and tighten the screws on the top of the ribbon
guide.
b. For 8.66" ribbon, move the ribbon guides against the inside wall of the
printer.
2. Slide an empty ribbon supply core onto the front ribbon rewind spindle,
fl ushed against the ribbon guide.
3. Slide a roll of ribbon supply onto the ribbon spindle fl ushed against the ribbon
guide with the leading edge hanging down, towards the back of the printer.
4. Pull the ribbon supply back, then down and thread it underneath the print
head mechanism and above the ribbon sensor
(black bar above media sensor).
Media Sensor
Ribbon Sensor
Figure 8
Print Head Mechanism
Ribbon Spindle
(back)
Ribbon Rewind Spindle (front)