User`s guide

SUPPLIES
IMPORTANT! Always turn OFF the power fi rst! Always wait at least 5 seconds before
turning the power back ON.
The ribbon and various printer media for the DuraLabel 4000 are optimized for
compatibility and print quality. Only authorized supplies from Graphic Products will
print correctly in the DuraLabel 4000.
Load Label Supply
IMPORTANT! Always turn OFF the power fi rst!
1. Open the printer cover by pressing the cover open buttons located on each side of
the printer cover.
2. Place label supply onto the supply shaft. Assemble the label stop plates on each
end of the supply shaft, centering the label supply using the measurements on the
supply shaft.
3. With the label supply extending over the top, towards the front of the printer, place
the loaded label supply spindle in the label mount slots at the back of the printer.
(A) 4" label supply installation
Label supply spindle set in label mount slots
Printer cover in open position
Left cover
open button
Right cover
open button
-7-