User`s guide

Clean Manual Cutter Module
1. Turn the printer power OFF.
2. Remove the screws on both sides of the
manual cutter module.
3. Unplug the sensor connector and remove the cutter
module.
4. Open a cleaning swab, and place the
swab between your index fi nger and
your thumb. Squeeze the swab until
it snaps. Alcohol will be distributed
to the cotton side of the swab. While
pressing down on the cutter, run a
cleaning swab back and forth several
times across the upper blade on of
the back side of the cutter.
5. Run the cleaning swab back
and forth several times across
the upper blade on the front
side of the cutter.
Press down on cutter
While cleaning the upper cutter blade
-46-